7 |
P a g e
13.
SECURE SCREWS ATTACHING INNER SIDE RAIL TO OUTER SIDE RAIL
************* IMPORTANT: DO NOT USE POWER TOOLS IN THIS STEP. **************
Using a hand screwdriver, secure the inner rail to the outer rail using the screws supplied. These screws
should not be tightened to the maximum. They should be turned enough so that (a) the screw head
does not interfere with the bottom bar end-caps, and (b) the screen panel is sufficiently taut from side
to side, and (c) the bottom weight bar can move ¼” to ½” side-to-side.
Test the motion of the screen panel to verify that the screw heads do not obstruct the bottom bar by
using the remote control to raise and lower the screen panel.
14.
INSTALL COVER ON CANISTER BACK ASSEMBLY
Hang the canister cover in the groove at the front top of the canister and secure it to the bottom using
the two screws that were removed in Instruction 5.
Measure the distance from the bottom edge of the canister cover and the bottom of the metal section
of the bottom weight bar. This dimension should be no less than 2 ¼”. If it is less than 2 ¼” it means that
the side zippers will not reliably stay in the entry guide and inner side rails. To fix this problem, follow
the instructions to reduce the upper limit so that the bottom weight bar hangs lower such that this
dimension is 2 ¼” or more.
15.
FINAL CHECKS
It is recommended that, with the bottom weight bar in the fully up position, a light spray of Dry Silicone
Lube be applied to the length of the inner side rail. This will assist with the smooth functioning of the
unit. Test the motion of the unit.
Leave the Yellow Limit Adjustment Tool with the customer for safekeeping and for use in the event that
the limits need to be adjusted.
16.
MAINTENANCE, CARE, AND USE
On a quarterly basis, a light spray of Dry Silicone Lube be applied to the length of the inner side rail. This
will assist with the smooth functioning of the unit.
Should the screen fabric become dirty, it may be washed using a mild detergent spray, e.g. Downy in a
spray container. Spray on detergent and wash down using a hose. Leave screen panel in the down
position to air dry.
Should the remote and motor become decoupled as a result of a power surge caused by inclement
weather or other circumstances, follow the instructions found in the accompanying document entitled
“Instructions for the Mystic Classic Remote and Motor” to re-couple the motor and remote.
