6 |
P a g e
10.
INSTALL THE BOTTOM WEIGHT BAR ASSEMBLY
NOTE: to perform the instruction in this section, you may need to adjust the temporary factory set limits
on the motor by following the instructions found in the accompanying document entitled “Instructions
for the Mystic Classic Remote and Motor”
Using the UP button on the remote, raise the bottom zipper to a comfortable level so that you can slide
the bottom weight bar on to the bottom zipper. If the bottom zipper stops before it reaches a
satisfactory level when the UP button is pressed, then follow the instructions to INCREASE the
temporary factory set upper limit.
On the screen panel, a small section of the bottom of the RIGHT SIDE ZIPPER is cut out so that the
bottom weight bar may be easily slid on to the bottom zipper. On the bottom weight bar, there is a
channel that receives the bottom zipper of the screen panel. Slide the bottom weight bar from right to
left on to the bottom zipper of the screen panel. Line up the T-ends of the bottom weight bar end-caps
with the center lines of the outer side rails.
Using the remote control, raise the bottom weight bar to approximately 2 inches from the top of the
outer side rail and let it hang there. Again, you will need to adjust the upper limit if the screen panel
does not roll up sufficiently.
11.
INSTALL THE INNER RAILS ASSEMBLY
****** DO NOT SCREW THE INNER RAIL TO THE OUTER RAIL UNTIL INSTRUCTION# 12 BELOW *******
Orient the inner rails, so that the black plastic entry guides installed on the inner rail is at the top.
For one of the inner rails, pass the T-end of the bottom weight bar end-cap into the rectangular channel
of the black plastic entry guide. Also, allow the teeth of side zipper of the screen panel to follow the T-
end of bottom weight bar end-cap into the same rectangular channel of the entry guide. Insert the inner
side rail firmly into the outer side rail.
Repeat the above instruction for the 2
nd
inner rail.
Allow the inner rail to stay loose inside of the outer rail. Do not attach any screws as yet.
12.
SET YOUR FINAL UPPER AND LOWER LIMITS FOR THE SCREEN PANEL
Follow the instructions in the accompanying “Instructions for the Mystic Classic Remote and Motor” to
set your final upper and lower limits for the screen panel.
NOTE: At its upper limit, the bottom weight bar must hang into the side rails such that the side zippers
are always contained below the plastic entry guides at the top of the inner side rails. The bottom weight
bar does not store in the canister. It hangs below the canister.
Test the motion of the screen panel by running it up and down once. Do not do this too many times as
the motor will shut down if it overheats. If this occurs, wait approximately 20 minutes for the motor to
cool down before proceeding.
