Page 21
Modulating Unitary Range
VA-LT206_11292016al
Side Reflectors & Bottom Shields
INSTALLATION
•
If used, install side shields (reflectors) and/or bottom shield as required. Refer to Figure 21 and Figure
22 for details.
•
Side shields are 124" (315cm) long. Fasten one side shield per reflector with #8 x ³/8" screws. Use three
side shield brackets per side shield. Space about 48" (122cm) apart, refer to Figure 21.
REFLECTOR HANGER
REFLECTOR
#8 X
3
8
" SCREW
(NOT SUPPLIED)
NOTCH THE SIDE REFLECTOR
FOR REFLECTOR BRACKETS
AND HANGERS
SIDE REFLECTOR
#8 X
3
8
" SCREWS
(NOT SUPPLIED)
SIDE REFLECTOR BRACKET
(APPROX. 48" APART)
TIGHTEN NUT
NOTE:
CLOSE ALL CHAIN LINKS "S" HOOKS, "J" BOLTS AND TURNBUCKLES OR ANY OPEN CONNECTION.
USE THE HOLE AS A GUIDE TO POSITION SIDE REFLECTOR.
THE SIDE REFLECTOR EDGE MUST BE VISIBLE THROUGH
THE HOLE AT ROOM TEMPERATURE.
REFLECTOR
SIDE REFLECTOR
BRACKET
SIDE REFLECTOR
SIDE REFLECTOR
RETAINER CLIP
SCREWS TO BE INSTALLED FROM INSIDE OF SIDE REFLECTOR.
INSTALL SCREWS ON ONE END OF THE RETAINER CLIP TO ALLOW MOVEMENT.
Figure 21: Side Shield Installation
