POWERL MANUAL
Page 11
Wi-Fi CONNECTION
To connect Wi-Fi enabled devices to a host.
1.
Connect the device to the host using the USB port and use the Master Setup to
set the data output mode to Wi-Fi.
2.
Open the file “config.ini” setup the parameters for Wi-Fi and host connection
(See the document “Config_ini” section Wi-Fi to learn how to set the
parameters for Wi-Fi communication).
3.
Save the settings and disconnect the device from the computer.
4.
The device tries to connect to the configured wireless network. The right LED
(4) flashes blue every second. If the device could connect to the wireless
network and to the host, the right LED (4) flashes slowly blue every 3 seconds.
If the device fails to connect, please check the parameters configured in the file
“config.ini”. Ask your network administrator for assistance if necessary.
Transmitting Barcode and/or RFID data to a host
Batch mode
All barcodes and RFID data scanned in batch mode are saved in the file “Output.txt” on
the removable drive “Scanndy”. Connect the device to the host computer via USB and
use the Windows-Explorer to navigate to the device “SCANNDY”. Copy the file
“Output.txt” to the host.
To delete the data from the device just delete the file “Output.txt”
Transmitting data from a Bluetooth or Wi-Fi device
When the scanner is paired to a host via Bluetooth, the data transmits to the host after
each scanning procedure and is not stored on the scanner unless the scanner moves
out of the range of the host. For out of range usage you can configure the device to
either store the data in a cache memory or do not allow scanning.
