9/04/2015
Free Standing Kiosk
Assembly and Operation Instructions
www.advancedkiosks.com
15
All the Parts for Bar code Scanner mount.
1. Take apart the plastic bar code reader mount that came with the bar code reader. You
will be left with the above parts: (from Left to Right) bottom, body, head, 3 inch long #8
screw (provided by AK) #8 washer, plastic washers, spacer, and washer. You need the
head piece and the two plastic washers that hold the head in the mount.
Scanner Bracket parts
2. The above picture shows how the parts need to be assembled. Using the 3 inch long
screw, put the #8 washer followed by the plastic washer (longer barrel ends toward the
washer) the scanner bracket head, the other plastic spacer (longer barrel end away from
bracket head) Spacer and fender washer.
3. The above assembly can now be screwed in to the blind threaded hole on the side of
the kiosk. The hole is only .20 deep, so thread the assembly into the desired hole and
when it bottoms out, tighten the nut to the wall of the kiosk.
4. Now tighten the other nut to keep the head from spinning. Do not over tighten.
