White
OUTPUT
500mA
Starter Kill Relay Control
(Starter Kill Relay is not required if installed with AK-PSB05)
Depending on jumper
(JP2)
selection this output can be used for:
Starter Kill Relay Control (Default)
Also known as Ground-
When-Armed. While armed (Smart Key not detected or LOCK
button pressed) this output provides a constant GND to disable the
starter circuit when an unauthorized ignition is commenced. Connect
the Starter Kill Relay according to the wiring diagram on the right.
Ground-When-Disarmed
Provides a GND signal while disarmed.
(Smart Key is detected or UNLOCK button pressed) This output can
be used as an enable signal to an immobilizer bypass or known as
Ground-When-Running. Alternatively this output can connect to any
system that requires an input signal when a Smart Key is sensed.
Purple
OUTPUT
100mA
Push-Start Module Control
Engine Push-Start Ignition Controller.
This output provides an encrypted signal to the Engine Push-Start Ignition controller only when system
sense a valid Smart Key or disarmed via the UNLOCK button or from the Bypass Transponder Card.
Brown
INPUT
Brake
Connect to the brake pedal switch that 12v when brake is applied, GND or float when released.
Note: This input is required for Smart Key programming and Ignition-Controlled Lock function.
Blue
OUTPUT
100mA
Window Closer Module Control
Connect to the optional Auto Window Closer Module trigger input.
Green
INPUT
Door Switch
-
directly. Change jumper (JP1) to
Positive Door Trigger if door
switch is a positive-triggered type.
Red
INPUT
ACC
**Required for Remote Start option**
This input must be
connected to a +12v source when ignition key is in the ACC
position.
Note:
With this input active, controller will stop search
for the Smart Keys to conserve
battery and avoid
unintended lock actuation while the vehicle is running.
Starter
Kill Relay
Control
NO
COM
NC
87
87A
30
85
86
ON
ACC
OFF
START (+)
ENGINE
START
Starter Kill Relay (Included)
5
© Copyright Advanced Keys Inc. 2011. All Rights Reserved.
ACCESSORY HARNESS WIRING DESCRIPTIONS
Wiring Description:
~
JP1
JP2
White
Purple
Brown
Blue
Green
Red
A
cc
e
ss
o
ry
H
ar
ne
ss
7-
Pi
n
22
A
W
G
Starter Kill Relay Control
Push-Start Module Control
Brake
Window Closer Module Control
Door Switch
ACC
~
-
+
+
-
+
-
JP2
JP1
OPTIONAL
JP
1
JP
2
JP
3
JP
4
OPTIONAL
ACC
Input
ON
ACC
OFF
START
VEHICLE
CIRCUIT
+12v
Dome
Light
Door
Sw itch
Door
Switch
Input
(Default) Negative Door Trigger (-)
Positive Door Trigger (+)
+12v
Dome
Light
Door
Switch
Door
Switch
Input
Ensure all connections are completed and properly secured
prior to connecting the wire harnesses to the module.
+
̶
+
̶
̶
NOTE
REQUIRED
