Advance acoustic 56314009, Service Manual

Page: 59 / 79

ELECTRICAL SYSTEM
FORM NO. 56043089 - AquaRide
™
- 57
PROGRAMMING VEHICLE SPEED CHANGES
The maximum high-speed M1 (transport) and maximum low speed M2 (scrub) can be changed electronically, using the handheld programmer. To
change a parameter using the programmer, press the PROGRAM key, and scroll down the Program Menu until the desired parameter is the top
line of the display. Press the appropriate CHANGE VALUE key (“up” or “down”) until the desired number is reached. The parameter is now set at
the desired value. All programming occurs in real time. In other words, the parameters can be changed while the vehicle is in operation.
The upper and lower limits of parameters are set at the factory. Some parameters have dependencies on other parameters. When the programmer
is being used to adjust a parameter and a limit is reached, the display will stop changing. To see why the display has stopped changing, press the
MORE INFO key. If the limit is related to another parameter, that information will be displayed; changing the value of the related parameter may
allow the original parameter to be adjusted further. Otherwise, the display simply says “Max Limit” or “Min Limit.”
Use of the programmer is described more fully in the
PROGRAMMER OPERATION section of this chapter.
MAINTENANCE
There are no user-serviceable parts inside the Curtis PMC 1228 controller. No attempt should be made to open the controller. Opening the
controller may damage it and will void the warranty.
However, it is recommended that the controller exterior be cleaned periodically, and if a handheld programmer is available, this periodic cleaning
provides a good opportunity to check the controller’s diagnostic history
fi le.
HANDHELD PROGRAMMER USE
Optional Curtis handheld programmer allows you to program, test and diagnose Curtis controllers. Use of a handheld programmer is described
more fully in the CURTIS PROGRAMMER MANUAL 56043101.