32
- FORM NO. 56043089 - AquaRide
™
SCRUB BRUSH SYSTEM
FRONT
X
Z
X
W
Z
W
Y
Y
CCW *
CCW *
Right side
belt
SCRUB BRUSH MOTOR(S) REMOVAL
1
See Figure 4. Remove the Belt Guards
(W)
(4 screws per side). With an operator in the driver’s seat with the key switch ON and the
maintenance mode scrub function selected press the drive pedal to start the scrub brushes and observe which brush motor needs to be
removed.
WARNING!
Disconnect the battery pack by activating the emergency stop switch/battery disconnect lever
(13)
before servicing.
3
Next loosen the scrub brush belt tension Hex screw in the center of the Belt Idler
(X)
(using 5/8” & 11/16” wrenches).
4
Remove the wiring at both the Pos. & Neg. brush motor terminal studs and note the correct wiring connections (for reinstallation). Then remove
the (3) Screws
(Y)
and lift the motor out from the scrub deck.
5
Reassemble in reverse order and adjust the belt tension to 3/4 - 7/8 inches (19-22 mm) as shown in Figure 5. Note: Install motors with wires
pointing to the rear towards the plastic motor wiring standoffs.
SCRUB BRUSH BELT REPLACEMENT
WARNING!
Disconnect the battery pack by activating the emergency stop switch/battery disconnect lever
(13)
before servicing.
1
See Figure 4. Remove the belt guard(s)
(W)
(4 screws each).
2
Important Service Tip:
The left and right side drive belts are not the same lengths they must be ordered individually (P.N. 56407465, left side
& P.N. 56407466, right side). Note: Single brush machine uses P.N. 56407465.
3
Loosen the scrub brush belt tension hardware on the Belt Idler Pulley
(X)
(using a 5/8” & 11/16” wrench). Pull the idler wheel away from the
backside of the belt and roll the belt off both the motor and brush pulleys. Then inspect for wear and replace as needed.
4
Re-install the drive belt and tension the belt as shown in Figure 5. Then install the belt guard, reconnect the battery pack and test the scrub
system for proper operation.
*Rotation of shaft from shaft end.
FIGURE 4
Summary of Contents for 56314009
