NetVanta 3100 Series Hardware Installation Guide
Physical Descriptions
61700600L2-34C
Copyright © 2015 ADTRAN, Inc.
19
NetVanta 3130 Rear Panel Design
The NetVanta 3130 rear panel is shown below.
Appendix A on page 37
provides pinouts.
Figure 7. NetVanta 3130 (with DBU) Rear Panel Layout
Figure 8. NetVanta 3130 (without DBU) Rear Panel Layout
NetVanta 3130 Rear Panel Interfaces
ADSL Interface
The NetVanta 3130 rear panel has an
ADSL
port to connect directly to ADSL, ADSL2, or ADSL2+
service. See
Table A-5 on page 38
for the ADSL connector pinouts.
DBU Interface (1700610L2 only)
The NetVanta 3130 has a
DBU
port on the rear panel to provide analog, V.90 dial backup. See
Table A-4 on page 38
for the DBU connector pinouts.
Factory Default Switch
The NetVanta 3130 has a factory default switch (labeled in
Figure 7
) on the rear of the unit. If the
factory default switch is pressed during bootup, the unit will stay in bootstrap mode. Since the unit has
no serial port, Telnet has been built into the boot code. The default IP address is 10.10.10.1.
The default switch must be pressed WHILE the STAT light is flashing green. Do not
press the default switch BEFORE the STAT light is flashing green, as this will cause
boot to be missed.
1
DBU
2
3
4
ADSL
1
0
Default
Switch
1
2
3
4
ADSL
1
0
Default
Switch
