ADTRAN 1202076L1, User Manual

Page: 93 / 123

Chapter 8. Telnet/Terminal Menus
61202076L1-1 TSU 600 User Manual 8-5
Remote Menu Access
Displays telnet menus for a remote device (may be another TSU/TDU
or any other ADTRAN product that supports telnet via its EIA-232 chain
port). After selecting this option, you may choose to connect to a device
entered in the Unit Access Table or enter a Unit ID for a unit not in the
Unit Access Table.
CTRL + X
terminates the session and returns to the
TSU 600 Main Menu.
Management Configuration
This menu sets management information, such as SNMP community
names and trap destination addresses.
Unit Access Table
This menu edits and creates the Unit Access Table. This table stores the
Unit ID, Passcode, and Unit Type for units connected via chain ports or
connected remotely to the TSU/TDU (see Figure 8-3 on page 8-6). An
entry in the table is only required to support proxy SNMP MIB access or
polling. For MIB access, an entry is required only if the unit's passcode
is not the same as the Default Unit Passcode, or the unit is a single port
TSU Stand-alone.
It is not necessary to have an entry in this table for a remote unit in order to
telnet to it or forward SNMP traps from it. In the telnet case, the Remote Menu
Access menu is selected from the Main menu and a Unit ID is entered which
may or may not be in the Unit Access Table.
Units accessed via T-Watch PRO over TCP/IP use the Unit ID and pass-
code set by T-Watch PRO running on the PC.