ADTRAN 1200218L1, User Manual

Page: 46 / 122

Chapter 3. Configuration
3-8 OSU 300 User Manual 61200663L1-1
Configuration Selections for DSX-1 Interfaces
The configuration selections listed in Table 3-3 are available for
Quad DSX-1 interfaces. Separate selections can be made for each of
the four DSX-1 ports of the card. The menu is shown in Figure 3-5.
Figure 3-5. Port Configuration Menu for Quad DSX-1 Interface Card
The Quad DSX-1 does not perform ESF to SF (D4) conversion through
the network. Therefore, both ends of the circuit must be configured for the
same framing type.
Table 3-3. DSX-1 Interface Port Configuration Selections
S
ELECTION
D
ESCRIPTION
I
NTERFACE
T
YPE
This read-only status field displays
Q
UAD
DSX-1
, indicating that a
Quad DSX-1 interface card is installed in the DTE Port card slot.
P
ORT
S
TATUS
This read-only status field displays
I
NACTIVE
,
A
CTIVE
,
W
AITING
,
E
RROR
, or
N
OT
I
NSTALLED
, indicating the current status of the DSX-
1 interface.
U
NALLOCATED
75
K
B
LOCKS
Displays the amount of bandwidth (in 75k increments) not already
allocated to any of the OSU 300 DTE ports.
P
ORT
S
TATE
If an individual DSX-1 interface is installed but not currently in use, set
to
D
ISABLED
. Set to
E
NABLED
to activate a port.