ADTEK CS2-PM, Operation Manual, Page: 33 / 44

CS2 SERIES
–OPERATION MANUAL(EN)-A-2017-11-16
30 / 41
Adjust the machinery structure to the higher signal output status(or any
higher status).
F
−
3
caLhi
6478h
699b h
caLhi
(CAL.Hi): Field Calibration High .
The high calibration is not need the
exactly "span" to calibrate because of the
"field calibration" function could be
calibrating any higher point.

Waiting for the value till stable,
pressed
Key to read signal high
of sensing device.

Waiting for above reading stable
(around 3~5seconds), press
Key again to complete the
calibration higher point, and go to
[
caLhs
].
F
−
4
caLhs
250)0
250) 0
2 50)0
caLhs
(CAL.HS): the value to be set is
relative to Field Calibration high point.
Settable range: -19999~29999
Shift Up Down Enter
F
−
5
Csel
deflt
deflt
field
Csel
(C.SEL): Calibration parameter
selection;
As the user finished the procedures of
field calibration, the field calibration datum
has been saved in EEProm and it can't
change the default(factory) calibration
datum . Even the field calibration has been
done, the user can still select either default
calibration or field calibration.
Programmable:
deflt
(default): factory calibration
points and factors
field
(field): field calibration points
and factors
Up Down Enter
◘
If the user select field
calibration of the
[
lOsc
]
(step
A-4) and
[
hIsc
]
(A-5) will be
replaced by the
[
caLls
]
and
[
caLhs
]
which it can not to be
change by anyone. If user has to
change the scaling, it's the only
way to access field calibration
level to set in
[
caLls
]
(step F-2)
and
[
caLhs
]
(step F-4).
◘
Please double check the
[
lOsc
]
(step A-4) and
[
hIsc
]
(A-5)
whether are correct after
selection the
deflt
or
field.
Go back to Measuring Page