Adtech ADT-HC8200, User Manual, Page: 77 / 97

XT20100820 HC8200 Flame Cutting Machine User’s Manual
3-53
3.3.2 Basic operation
There are some basic operations under Auto processing interface, as follow:
Preview
The system only runs X and Y trails, but the output switches such as preheating oxygen, gas control and
cutting control will not open. It is used to predict the trail and check whether the size of the steel plate is correct.
Oxygen gas
The system is performing oxygen gas cutting craftsmanship.
Plasma
The system is performing plasma cutting craftsmanship.
Spraying
The system is performing powder spray marking craftsmanship.
Plasma mark
The system is performing plasma marking craftsmanship.
Moving function
Under the main interface, press the + or – key to zoom in or zoom out the Shape. Press + once, the Shape
zooms in by 2 times and press - once, the Shape zooms out by 1/2.
Press Shift and
←,↑,→or↓
at the same time, you can translate the Shape. Press once to move the Shape
by 1/4 of the screen.
Preheat delay
While preheating, the bottom right of the interface will display the total time of preheating and the time
already lapsed. At this time, if you press F8, the system will stop preheating and go to next action; if you press F6
once, the preheating time will be prolonged for 2 seconds; if the preheating time is enough, you can press F8 to
stop preheating and go to the next action. If you press F7, the system will save the current preheating time for
future use, and then go to next action.
Restart after pause
When the cutting torch is on the motion trail, press START to cut along the trail; when the torch is moved out