TMR is set to 40 Mbps.
Both channels have a HD1920x1080i source.
Both channels audio = 256 kbps
Video fill is set to off.
If both encoders are set to 19.10 Mbps and you want to reconfigure them to say 15.00 Mbps for
channel 1 and 25.00 Mbps for channel 2. This would cause an egress overflow condition
because you have not factored in the 3.5% reserve and bandwidth occupied by audio pids.
Even though VAF is set to off it’s logic will override the configuration request and constrain the
video rates back down to 19.10 Mbps for both channels. To obtain the desired configuration.
You would need to recalculate your rates. Then configure channel 1 to 15.00 Mbps then
channel 2 to 23.00 Mbps.
How to enable EAS mode
EAS can be enabled from an automation system contact closure or from the webUI EAS tab.
To enable EAS in VIDEO+AUDIO via the 9 Pin GPIO, short pin 5 to pin 7.
EAS GPIO Connector Pinout
To enable EAS mode from the webUI. Click the EAS tab. Select the desired EAS mode, then
click the large GO button. To disable EAS mode press the large STOP button.
How to configure Network EAS Triggering
By default the EN-20 is configured to send a trigger over the network to all other dual
channel encoders (HDMI2QAM, YUV2QAM, or EN-20) to also enter EAS enabled state. This
feature can be disabled by unchecking the box next to “Network EAS Triggering” then
pressing the apply button on the EAS tab.
Audio passthru - Dolby E / 5.1 / 2.0, Dolby D, LPCM
The Adtec EN-20 encoder supports one pair of audio encoding or one pair of audio passthru.
An audio passthru consists of a compressed bitstream ( Dolby E 20 Bit / Dolby E 16 Bit /
Dolby Digital / Linear Acoustic Stream Stacker 2 ) or an uncompressed stereo pair ( LPCM )
Summary of Contents for EN-20
Page 35: ......