ADT Safewatch Plus Enterpreneur Security Systems, User Manual

Page: 7 / 28

DISARMING
Your system is programmed with one or more entrance delay zones which allow
time to enter the premises without causing an alarm. Each delay door may be
programmed with a different entry time. Be sure to check with your installer.
Note: If your system has the Follower” feature enabled, all
interior designated zones automatically become delay zones whenever
you first
enter through a delay zone. This allows you to walk In front of
motion
detectors on the way to the control station after you enter.
1.
After entering the premises through a delay zone, the control station will sound
a continuous tone to remind you to disarm the system.
CAUTION: If the ALARM is lighted, an alarm has occurred.
Leave the premises immediately and go
to the nearest phone to contact
the appropriate
authorities. Do not into the premises.
2.
Enter your User Code.
3. The red armed light should turn off indicating that the system is disarmed.
Testing the Burglar and Fire Alarm Audibles
UL listed burglar and fire alarm systems which have separate audible
sounding devices require a weekly test. Notify the Central Station or the
appropriate authorities before and after conducting the test. Use the
following procedures.
Burglar
alarm
1. Arm the system by following the instructions on the preceding pages.
2. Upon expiration of the exit delay open a non-delayed door, window, or
motion detector. The sounding device will activate. To reset, follow the
instructions on disarming the system.
Fire
alarm
1. Follow the procedure
for
activation of the auxiliary alarms as outlined on
page of this manual.
5