– 7 –
MECHANICS OF PROGRAMMING
This section provides information on how programming is performed in this
system. It will enable you to understand how to enter and exit the programming
mode, and how to program the data fields and the user-friendly interactive
menu modes (
✱
56,
✱
80,
✱
81,
✱
82,
✱
83). We therefore urge you to read and
understand the following before proceeding with any programming.
General Programming Information
Characteristics for each installation are stored in non-removable, electrically
erasable, non-volatile EEROM memory. Most of the data fields have been
programmed for “standard” ADT values. However, there are some fields that
must be programmed for each particular installation to establish its specific
alarm and reporting features. These include such fields as
✱
40: PABX ACCESS
CODE,
✱
41: PRIMARY PHONE NUMBER,
✱
42: SECONDARY PHONE NUMBER, etc.
The Programming Form in this manual shows those data fields that have been
pre-programmed for ADT (values for fields that have been factory-programmed
for ADT are shown in the boxes adjacent to those fields).
It is possible to program the system at any time, even at the installer's premises
prior to the actual installation. Simply apply power temporarily to the control
and then program the fields that need to be programmed, as desired.
Important Note: You cannot enter the programming mode unless the
system is disarmed.
There are two programming modes: data field programming and interactive
menu mode programming. Data field programming is used for setting various
system options and menu programming is used for programming zone
information, programming relay outputs, and for enrolling 5800 series
transmitter serial numbers.
To program the system, you must use a 6139ADT two-line Custom English
touchpad connected to touchpad terminals on the control (4, 5, 6, & 7). A
Custom English touchpad need not necessarily remain in the system after
programming.
Programming can also be performed remotely from the installer’s office/home,
using an IBM personal computer , a modem, and Windows downloading software.
See the REMOTE PROGRAMMING AND CONTROL (DOWNLOADING)
section in this manual .
Entering the Program Mode
You may use one of the following methods:
(a) Press both the [
✱
] and [#] keys at the same time within 50 seconds after
power is applied to the Control, or
(b) After power up, enter the following: ADT Installer code: (6 3 2 1) + 8 + 0.
Method (b) is disabled if you exit the program mode using
✱
98 instead of
✱
99. See “Exiting the Program Mode” paragraph later in this section.
Following entry into the program mode, data field
✱
20 will be displayed (this is
the first field in the system). You can then proceed to program those fields that
require programming (see the next paragraph, “Programming a Data Field”).
Programming a Data Field
1. Press [
✱
] plus Field No. (for example,
✱
41), then make the required entry.
2. When you have completely programmed a data field, the touchpad will
“beep” three times and then automatically display the next data field in
sequence. To go to a different field, press [
✱
] plus the desired field No.
Summary of Contents for SA10ADTEG
Page 22: ... 22 NOTES ...
