ADLINK Technology Express-KL2, User Manual

Page: 26 / 96

20
Pinouts and Signal Descriptions
3.3.15. Power and System Management
Signal Pin # Description I/O PU/PD Comment
PWRBTN# B12 Power button to bring system out of S5 (soft off), active on
falling edge.
I 3.3VSB PU 10k
3.3VSB
SYS_RESET# B49 Reset button input. Active low request for module to reset
and reboot. May be falling edge sensitive. For situations
when SYS_RESET# is not able to reestablish control of the
system, PWR_OK or a power cycle may be used. I 3.3VSB PU 10k
3.3VSB
CB_RESET# B50 Reset output from module to Carrier Board. Active low.
Issued by module chipset and may result from a low
SYS_RESET# input, a low PWR_OK input, a VCC_12V
power input that falls below the minimum specification, a
watchdog timeout, or may be initiated by the module
software.
O 3.3VSB PD 100K
PWR_OK B24 Power OK from main power supply. A high value indicates
that the power is good. This signal can be used to hold off
Module startup to allow carrier based FPGAs or other
configurable devices time to be programmed. I 3.3V PU 10k
3.3VSB Should
have weak
pull up
SUS_STAT# B18 Indicates imminent suspend operation; used to notify LPC
devices.
O 3.3VSB
SUS_S3# A15 Indicates system is in Suspend to RAM state. Active-low
output. An inverted copy of SUS_S3# on the carrier board
(also known as “PS_ON”) may be used to enable the non-
standby power on a typical ATX power supply. O 3.3VSB
SUS_S4# A18 Indicates system is in Suspend to Disk state. Active low
output. O 3.3VSB
SUS_S5# A24 Indicates system is in Soft Off state. O 3.3VSB
WAKE0# B66 PCI Express wake up signal. I 3.3VSB PU 1K
3.3VSB
WAKE1# B67 General purpose wake up signal. May be used to
implement wake-up on PS/2 keyboard or mouse activity. I 3.3VSB PU 1K
3.3VSB Connect to
WAKE 0#
BATLOW# A27 Battery low input. This signal may be driven low by external
circuitry to signal that the system battery is low, or may be
used to signal some other external power-management
event.
I 3.3VSB PU 10k
3.3VSB