Getting Started
11
Figure 2-4: Unlatching and removing a cPCI PSU
2. Pull outwards to remove the PSU.
3. Insert the new PSU module, push on the handle until it
latches into position, and replace the retaining screws.
2.3 Rear Transition Module Installation/Removal
The installation and removal procedures for a Rear Transition
Module (RTM) are the same as those for CompactPCI boards.
Because they are shorter than front boards, pay careful attention
when inserting or removing RTMs. Only models with an “R” at the
end of the model number support RTMs.
Note: We strongly recommended the use of RTMs with AB type
connectors to prevent the damage to the backplane during
RTM installation.
Summary of Contents for cPCIS-3330 Series
