Getting Started
7
2
Getting Started
This chapter describes the unpacking procedure of the sub-sys-
tem and installation procedures for CompactPCI boards, power
supply units (PSUs) and drive bays.
2.1 Shipping Contents
Check the shipping carton for any damage. If the shipping carton
and contents are damaged, please notify the dealer for a replace-
ment. Retain the shipping carton and packing material for inspec-
tion by the dealer. Obtain authorization before returning any
product to ADLINK.
Check that the following items are included in the package. If there
are any missing items, please contact your dealer:
X
One cPCIS-3330 Series Subsystem
X
This User’s Manual
X
Accessory Kit (includes N. American or European power
cord, air filter and spare screws)
2.2 CompactPCI Card & PSU Installation
The CompactPCI connectors are rigid and require careful handling
when inserted and removed. Improper handling of cards can eas-
ily damage the backplane.
The system slot is red, peripheral slots are gray, and PSU slots are
green. Be certain to insert each module into the correct type of
slot.
System slots have obvious indicators (e.g. red card guide rail, tri-
angle mark enclosing the slot number on the backplane) A system
board can only be installed in a system slot. Do not insert a system
board into any other slot, or insert any peripheral card into a sys-
tem slot.
Summary of Contents for cPCIS-3330 Series
