ADLINK Technology CoreModule 430, Reference Manual

Page: 33 / 56

Chapter 3 Hardware
CoreModule 430 Reference Manual 27
Note: The shaded table cells denote power or ground. The * symbol indicates the signal is Active Low.
12 FP5 Panel Data 5 – Refer to pin 9, FP2, for more information.
13 FP6 Panel Data 6 – Refer to pin 9, FP2, for more information.
14 FP7 Panel Data 7 – Refer to pin 9, FP2, for more information.
15 NC Not connected (FP8 = Panel Data 8)
16 NC Not connected (FP9 = Panel Data 9)
17 FP10 Panel Data 10 – Refer to pin 9, FP2, for more information.
18 FP11 Panel Data 11 – Refer to pin 9, FP2, for more information.
19 FP12 Panel Data 12 – Refer to pin 9, FP2, for more information.
20 FP13 Panel Data 13 – Refer to pin 9, FP2, for more information.
21 FP14 Panel Data 14 – Refer to pin 9, FP2, for more information.
22 FP15 Panel Data 15 – Refer to pin 9, FP2, for more information.
23 NC Not connected (FP16 = Panel Data 16)
24 NC Not connected (FP17 = Panel Data 17)
25 FP18 Panel Data 18 – Refer to pin 9, FP2, for more information.
26 FP19 Panel Data 19 – Refer to pin 9, FP2, for more information.
27 FP20 Panel Data 20 – Refer to pin 9, FP2, for more information.
28 FP21 Panel Data 21 – Refer to pin 9, FP2, for more information.
29 FP22 Panel Data 22 – Refer to pin 9, FP2, for more information.
30 FP23 Panel Data 23 – Refer to pin 9, FP2, for more information.
31 TFTEnVcc TFT Power (Vcc) – This signal is the power to flat panel displays.
32 TFTEnVee TFT Backlight Enable – This signal enables power to flat panel displays.
33 +PNLVdd Voltage (+3.3 or +5 volts ±5%) depends on setting of JP6.
34 +12V Out +12 volts ±5%
35 GND Ground
36 GND Ground
37 HSYNC Horizontal Sync – This signal is used for the digital horizontal sync output to the
CRT. Also used (with VSYNC) to signal power management state information to
the CRT per the VESA

DPMS

standard.
38 VSYNC Vertical Sync – This signal is used for the digital vertical sync output to the CRT.
Also used (with HSYNC) to signal power management state information to the
CRT per the VESA

DPMS

standard.
39 AGNDR Analog Ground for Red
40 RED Red – This pin provides the Red analog output to the CRT.
41 AGNDG Analog Ground for Green
42 GREEN Green – This pin provides the Green analog output to the CRT.
43 AGNDB Analog Ground for Blue
44 BLUE Blue – This pin provides the Blue analog output to the CRT.
Table 3-12. Video Interface Pin/Signal Descriptions (J11) (Continued)