Page 42
nanoX-BT
Feature
Options
Description
V3.30
Read only
Display actual V3.30 voltage
VIN
Read only
Display actual VIN voltage
AIN7
Read only
Display actual AIN7 voltage
7.2.6.4.
System Management > Runtime Statistics
Feature
Options
Description
Runtime Statistics
Info only
Total Runtime
Read only
The returned value specifies the total time in minutes the system
is running in S0 state.
Current
Runtime
Read
only
The returned value specifies the time in seconds the system is
running in S0 state.
This counter is cleared when the system is removed from the
external power supply.
Power
Cycles
Read
only
The returned value specifies the number of times the external
power supply has been shut down
Boot Cycles
Read only
The Bootcounter is increased after a HW- or SW-Reset or after a
successful power-up.
Boot Reason
Read only
The boot reason is the event which causes the reboot of the
system.
7.2.6.5.
System Management > Flags
Feature
Options
Description
Flags Info
only
BMC
Flags
Read
only
BIOS Select
Read only
Display the selection of current BIOS ROM
ATX/AT-Mode
Read
only
Display
ATX/AT-Mode
Exception
Code
Read
only
System
exception
reason
7.2.6.6.
System Management > Power Up
Feature
Options
Description
Power Up
Info only
Power Up watchdog
Attention: F12 disables the Power Up
Watchdog.
Enabled
Disabled
The Power-Up Watchdog resets the system after a certain
amount of time after power-up.
ECO
Mode
Disabled
Enable
Reduces the power consumption of the system
Power-up
Mode
Attention: The Power-Up Mode only has effect,
if the module is in ATX-Mode.
Turn on
Remain off
Last State
Turn On: The machine starts automatically when the power
supply is turned on.
Remain Off: To start the machine the power button has to be
pressed.
Last State: When powered on during a power failure the system
will automatically power on when power is restored.
