ADLINK Technology AdvancedMC AMC-8100, User Manual

Page: 50 / 76

36 BIOS Features
/pci@8,700000/IntraServer,fc@1,1/disk
/pci@8,700000/IntraServer,fc@1,1/tape
/pci@8,700000/IntraServer,fc@1/disk
/pci@8,700000/IntraServer,fc@1/tape
/pci@8,700000/scsi@6,1/tape
/pci@8,700000/scsi@6,1/disk
ok
X
/pci@8,700000/IntraServer,fc@1
identifies the first FC interface on an LSIFC949X/
949E-based adapter.
X
/pci@8,700000/IntraServer,fc@1,1
identifies the second FC interface on an LSIFC949X/
949E-based adapter.
If these devices are not listed, check to assure that the adapter is
correctly installed, and reseat the adapter in the PCI slot if neces-
sary.
5.5.4 Adapter-Specific Settings
In certain circumstances, advanced users may want to change
settings for an individual adapter or port, without affecting the
other adapters in the system. Specific examples of such settings
are FC bus speed, host adapter ID (SCSI only: Not Applicable to
FC), and Interrupt Coalescing.
To select a specific Fusion-MPT adapter as the current adapter,
use the
select
command. Selecting a port or adapter brings the
port online and allows you to show or set certain adapter specific
parameters.
You should use caution while issuing the following commands
because some commands (such as forcing 1 Gbit/s operation on a
2 Gbit/s FC loop) could render the bus unusable.
NOTE: NOTE:
The above listing is an example. The
show-devs
output may
vary depending on your system and configuration. Use the cor-
responding entries on your system, not the ones given here.