4 of 11
STEP 2: WALL MOUNTING PANEL INSTALLATION
2A
.
Carefully unpack the balance of the Adjust-a-Sink® System and verify all components are
included and undamaged. The Adjust-a-Sink® System comes with most of its components already
assembled.
2B
. Install the shampoo bowl Sink Mounting Bracket and the Lift Backsplash with the hardware
provided. (Use the proper size screws and quantities as required; lock washers and nuts go on the
backside
of the Lift Panel.)
NOTE:
The Lift Panel is predrilled with the proper number of holes and
spacing for either the Marble Products 3000W or Belvedere 8400 Shampoo Bowl.
Due to its metal components and sturdy construction, the assembled Adjust-a-Sink
®
is quite heavy.
Because of this, and to ensure proper operation, it is recommended to locate wall-framing studs
behind the finished wall and then fasten the Wall Mounting Panel to the studs using multiple, long
length sheet rock screws (not supplied). In some installations where framing members may fall
outside the Wall Mounting Panel, apply a generous amount of construction adhesive (not supplied)
around the entire back of the panel and secure it to the wall that way. Consult adhesive instructions
for proper conditions and restrictions.
If your Wall Mounting Panel requires a different installation arrangement, it is the installer’s
responsibility to calculate, verify and drill the panel according to the guidelines already established.
Again, review drawing
K100-87
Plumbing Rough-In for details.
IMPORTANT: When securing the unit to a sturdy cabinet, we suggest that you use (4) 5/16”
bolts of the appropriate length with (2) 5/16” fender washers, and 1 lock washer and nut per
bolt. Space these (4) bolts in a manner that provides maximum support and affords coverage
by the Shroud so that bolts are not visible post installation.
2C
.
Once the Wall Mounting Panel is positively secured to the wall, align the hydraulic lift Floor Plate
by adjusting the two socket-set screws hidden beneath the Retainer Ring. See item # 2 on drawing
K100 sheet 2.
Remove the six #10-24 pan head screws as indicated but do not discard. Using a 5/32 hex key, turn
the two screws equally clockwise: the requirement is to make the Floor Plate perpendicular to the
Wall Mounting Plate. Using a small carpenter’s square, place one edge up against the Wall
Mounting Panel and gauge according. When perpendicular, reinstall the six #10-24 pan head
screws. Apply a bead of silicone based caulking (not supplied) all around the base of the Lift Plate at
the floor; this will keep water and other grime from collecting underneath. Additionally, seal all along
the Wall Mounting Plate bottom edge, where it rests on the floor.