3 of 11
Water Supply Lines:
1/2” ID rigid copper tube:
HOT
: Refer to Drawing K100-87 for the Location of the Water Lines
COLD
: Refer to Drawing K100-87 for the Location of the Water Lines
Stub out 4” from the finished wall.
IMPORTANT: Since many installations may not be able to locate the plumbing rough in exactly
as specified, refer to Drawing K100-87 Plumbing “Rough-In” for the allowable areas plumbing
may penetrate the Wall Mounting Panel. Caution! Plumbing falling outside this area may
cause interference problems with moving sink components. Other plumbing drain/water
configurations such as rough in through the floor are permissible; however the installation
becomes the responsibility of the installer.
1B: Drilling/Hole Cutting the necessary holes in the Mounting Panel for water supply lines and
Drain Pipe:
Unpack the Wall Mounting Panel along with the Lift Backsplash. Mark the hole
locations on the Mounting Panel per the dimensions that correspond to where the water supply lines
and drains are located on the wall (or sturdy cabinet) on which it will mount. Before you begin, verify
once more that the wastewater drain pipe and supply water stub-outs have been properly located per
drawing
K100-87
Plumbing Rough-In. We suggest that you use the following to drill out the
necessary through holes on the mounting panel:
7/8” Min. Dia. – Hot, Cold Water Lines
2 1/4” Min. Dia. Hole Saw – Waste Drain