ADJ Products, LLC - www.adj.com - Zipper Instruction Manual Page 12
3. Press the UP or DOWN buttons to find your desired dimmer
curve and press ENTER to confirm. See the Dimmer Curve
Chart on page 21 for more information.
LED -
With this function you can have the LED display
backlight turn off after 10 seconds.
1. Press the MENU button until “
LED
” is displayed, press
ENTER.
2. The display will show either “
ON”
or
“OFF
”. Press the UP or
DOWN buttons to select “
ON
” to keep the LED display on at
all times, or “
OFF
” to switch to have the LED display switch off
after 10 seconds.
3. Press ENTER to confirm. To make the LED display reappear
after it has turned off, press any button.
DISP
-
This function will reverse the display 180º.
1. Press the either the MENU button until “
DISP
” is displayed,
press ENTER.
2. Press the UP button to select “
DSIP
” to “flip” the display, or
“
DISP
” to change the display back.
3. Press ENTER to confirm.
TILT -
Tilt Inversion
1. Press the MENU button until “
TILT
” is displayed, press
ENTER. Either “YES” or “YES” will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until YES is displayed, press ENTER to confim. To deactivate
Tilt inversion, select NO and press Enter.
Zipper
System Menu
ADJ Products, LLC - www.adj.com - Zipper Instruction Manual Page 15
Zipper
Operation
“100” being the most sensitive. Press ENTER to set your level.
Show Mode:
This mode allows either a single unit or several units
linked together, to run one of 16 shows that you choose. Show mode
can run with or without sound active mode.
1. Press the MENU button until “
SHND
” is displayed, and press
ENTER.
2. Press the UP or DOWN buttons until you find your desired show,
press ENTER, then press and hold the MENU button for at least 3
seconds to activate. After you have set your desired show, it can
be changed at any time using the UP or DOWN buttons.
Master-Slave Configuration
This function will allow you to link up
to 16 units together and operate without a controller. The units will
be sound activated. In Master-Slave operation one unit will act as the
controlling unit and the others will react to the controlling units pro-
grams. Any unit can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit press the MENU button until “
SLND
” is dis-
played, and press ENTER. Use the UP and DOWN buttons to
scroll to the “MAST” setting and press ENTER.
3. After setting the Master unit to the master setting find your
desired operating mode.
4. On the slave units press the MENU button until “
SLND
” is dis-
played, and press ENTER. Choose either “
SL 1
” or “
SL 2
” and
press ENTER. See page 10 for more info.
5. The slave units will now follow the Master unit.
Zipper
Master-Slave Set Up
