ADJ Products, LLC - www.adj.com - Zipper Instruction Manual Page 11
sensitive, and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to
confirm.
DNST
- This mode can be used as a precaution mode,
that in case the DMX signal is lost, interrupted, or power is
lost, the operating mode chosen in the setup is the running
mode the fixture will go into when the DMX signal is lost. You
can also set this as the operating mode you would like the
unit to return to when power is applied.
1. Press the MENU button until “
DNST
” is displayed, and either
“
MASL
”, “
BLND
”, or “
LAST
” will be displayed beneath.
2. Press ENTER and the bottom choice will begin to flash. Use
the UP or DOWN buttons to choose an operating mode you
would like the unit to start up in when power is applied or the
DMX signal is lost.
•
MASL (Master-Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode
and run a built-in show.
•
BLND (Blackout) - If the DMX signal is lost or interrupted, the
unit will automatically go into stand by mode.
•
LAST
- If the DMX signal is lost or interrupted the fixture will
stay in the last DMX setting. If power is applied and this mode is
set, the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
DIND -
In this mode you can select the dimmer curve.
1. Press the MENU button until “
DIND
” is displayed, press
ENTER.
2. The current dimmer curve setting will be displayed.
Zipper
System Menu
ADJ Products, LLC - www.adj.com - Zipper Instruction Manual Page 16
The
UC IR
infrared remote gives you control of various functions
(See below)
. To control the fixture you must aim the remote at the
front of the fixture and be no more then 30 feet away.
STAND BY
-
Pressing this button will blackout the fixture.
FULL ON
-
Pressing the button will put the output at full intensity.
When the button is released the output will return to the normal state.
FADE/GOBO
-
Invalid for this fixture.
“” and “DIMMER -” -
Invalid for this fixture.
STROBE
-
This button will activate the strobe effect. If you press and
hold this button the unit will begin to strobe.
COLOR
-
Invalid for this fixture.
SOUND ON & OFF -
These buttons activate and deactivate the
sound active mode.
SHOW 0 -
Press this button to activate the show mode. Use buttons
1-9 to select your desired show. To access shows 11-16, press the
SHOW 0 button again, and use buttons 1-6 to select shows 11-16.
Zipper
UC IR Remote Control
