Vizi Beam RXONE
Offset Menu
Gobo - Setting adjustment for the gobo wheel.
1. Press the ENTER button for at least 5 seconds, then press the UP or DOWN buttons so that
“Gobo” is displayed. Press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and then press ENTER to confirm.
Press the MENU button for one second to exit.
Prism - Setting adjustment for the 1st prism.
1. Press the ENTER button for at least 5 seconds, then press the UP or DOWN buttons so that
“Prism” is displayed. Press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and then press ENTER to confirm.
Press the MENU button for one second to exit.
ADJ Products, LLC - www.adj.com - Vizi Beam RXONE User Manual Page 32
Vizi Beam RXONE
Operation
Sound Active Mode: This mode allows either single unit or several units linked together to run
to the beat of the music.
1. Press the MENU button until “Sound State” is displayed, and press ENTER.
2. Press the UP or DOWN buttons so that “ON” is displayed and press ENTER.
3. Press the MENU button until “Sound Sense” is displayed, and press ENTER.
4. Use the UP and DOWN buttons to adjust the sound sensitivity, and press ENTER once you have
found your desired sensitivity level.
Show Mode: This mode allows either a single unit or several units linked together to run one of
four shows that you choose.
1. Press the MENU button until “Show Mode” is displayed, and press ENTER.
2. Press the UP or DOWN buttons to find your desired show, and press ENTER.
Vizi Beam RXONE
Primary-Secondary Set Up
Primary-Secondary Operation: This function will allow you to link up to 16 units together and oper-
ate without a controller. The units will be sound activated. In Primary-Secondary operation, one unit
will act as the controlling unit and the others will react to the controlling units programs. Any unit can
act as a Primary or as a Secondary.
1. Using approved DMX data cables, daisy chain your units together via the XLR connector on the
rear face of each unit. Remember the Male XLR connector is the input and the Female XLR con-
nector is the output. The first unit in the chain (primary) will use the female XLR connector only,
while the last unit in the chain will use the male XLR connector only. For longer cable runs we
suggest installing a terminator at the last fixture.
2. On the Primary unit press the MENU button until “Pri/Sec” is displayed, and press ENTER. Use
the UP and DOWN buttons to scroll to the “Pri” setting and press ENTER.
3. After setting the Primary unit to the primary setting, find and set the desired operating mode.
4. For each secondary unit, press the MENU button until “Pri/Sec” is displayed, and press ENTER.
Choose either “Sec 1” or “Sec 2” and press ENTER.
5. The secondary units will now follow the primary unit.
