A.D.J. Supply Europe B.V.
– www.adj.eu – Element QAIP Instruction Manual Page 17
OPERATING INSTRUCTIONS
LCD Display Lock:
The display will lock after 30 seconds. Press and hold the MODE button for at least 10 seconds to unlock the
display.
Operating Power:
There are two ways to supply power to this unit; battery power or AC power.
• AC Power -
To run the unit using AC power, plug the unit into a power source, and activate the Load setting.
When using AC power make sure the Battery Switch is in the OFF position.
• Battery Power -
To run the unit using Battery power, switch the battery switch located on the bottom of the
fixture into the “On” position, and activate the Load setting.
Load Setting
You need to activate this function regardless of Battery power or AC power. This function activates the LED
PCB output
1. To activate Load, press the MODE button until either “bXXX”, “bsXX”, or “LoXX” is displayed. “XX” is the
represents the current setting of those menus.
2. Press the SET UP button so that “LoXX” is displayed. “XX” represents either “oN” or “oF” (Off).
3. Press the UP or DOWN buttons so that “oN” is displayed.
Energy Saving Mode
This will decrease the LED’s brightness gradually when the battery life is less than 80%, this is will extend the
battery life.
1. To activate energy saving mode, press the MODE button until either “bXXX”, “bsXX”, or “LoXX” is displayed.
“XX” is the represents the current setting of those menus.
2. Press the SET UP
button so that “bS:XX” is displayed. “XX” represents either “ON” or “OFF”.
3. Press the UP or DOWN button so that “ON” is displayed. If “ON” is displayed already then, the fixture is
already in energy saving mode.
LED Display On/Off:
To set the LED displa
y light to turn off after 20 seconds, press the MODE button until “dXX” is displayed. “XX”
represents either ON or OFF. Press the UP or DOWN buttons so that OFF is displayed. Now the display light
will turn off after 30s. Press any button to turn the display on again.
Operating Modes:
The Element QAIP has five operating modes:
• RGBA Dimmer Mode - Choose one of the four colors to remain static or adjust the intensity of each color to
make your desired color.
• Sound-Active mode - The unit will react to sound, chasing through the built-in programs. There are 16 sound
active modes.
• Auto Run Mode - In Auto Run mode, you can choose 1 of 16 color change modes, 1 of 16 color fade modes,
or a combo color change & fade mode.
• Static Color Mode - There are 63 colors to choose from.
• DMX control mode - This function will allow you to control each individual fixtures traits with a standard DMX
512 controller.
