background image

  

Dotz Panel 2.4 

                                                                                                 

Warranty

ADJ Products, LLC  -  www.adj.com  - Dotz Panel 2.4 User Manual Page 22

MANUFACTURER’S LIMITED WARRANTY

A.  ADJ Products, LLC hereby warrants, to the original purchaser, ADJ Products, LLC products to be free of 

manufacturing defects in material and workmanship for a prescribed period from the date of purchase 

(see specific warranty period on reverse). This warranty shall be valid only if the product is purchased 

within the United States of America, including possessions and territories. It is the owner’s responsibility 

to establish the date and place of purchase by acceptable evidence, at the time service is sought.

B.  For warranty service you must obtain a Return Authorization number (RA#) before sending back the prod-

uct–please contact ADJ Products, LLC Service Department at 800-322-6337. Send the pro- duct only to 

the ADJ Products, LLC factory. All shipping charges must be pre-paid. If the requested repairs or service 

(including parts replacement) are within the terms of this warranty, ADJ Products, LLC will pay return ship-

ping charges only to a designated point within the United States. If the entire instrument is sent, it must 

be shipped in its original package. No accessories should be shipped with the product. If any accessories 

are shipped with the product, ADJ Products, LLC shall have no liability whatsoever for loss of or damage 

to any such accessories, nor for the safe return thereof. 

C.  This warranty is void if the serial number has been altered or removed; if the product is modified in any 

manner which ADJ Products, LLC concludes, after inspection, affects the reliability of the product; if the 

product has been repaired or serviced by anyone other than the ADJ Products, LLC factory unless prior 

written authorization was issued to purchaser by ADJ Products, LLC; if the product is damaged because 

not properly maintained as set forth in the instruction manual. 

D.  This is not a service contract, and this warranty does not include maintnance, cleaning or periodic check 

up. During the period specified above, ADJ Products, LLC will replace defective parts at its expense with 

new or refurbished parts, and will absorb all expenses for warranty service and repair labor by reason of 

defects in material or workmanship.  The sole responsibility of ADJ Products, LLC under this warranty 

shall be limited to the repair of the product, or replacement thereof, including parts, at the sole discretion 

of ADJ Products, LLC.  All products covered by this warranty were manufactured after August 15, 2012, 

and bear indentifying marks to that effect.

E.  ADJ Products, LLC reserves the right to make changes in design and/or improvements upon its products 

without any obligation to include these changes in any products theretofore manufactured. 

No warranty, whether expressed or implied, is given or made with respect to any accessory supplied with 

products described above. Except to the extent prohibited by applicable law, all implied warranties made 

by ADJ Products, LLC in connection with this product, including warranties of merchantability or fitness, are 

limited in duration to the warranty period set forth above. And no warranties, whether expressed or implied, 

including warranties of merchantability or fitness, shall apply to this product after said period has expired. The 

consumer’s and/or Dealer’s sole remedy shall be such repair or replacement as is expressly provided above; 

and under no circumstances shall ADJ Products, LLC be liable for any loss or damage, direct or consequen-

tial, arising out of the use of, or inability to use, this product. 

This warranty is the only written warranty applicable to ADJ Products, LLC Products and supersedes all prior 

warranties and written descriptions of warranty terms and conditions heretofore published.

MANUFACTURER’S LIMITED WARRANTY PERIODS:

•  Lighting Products = 1-year (365 days) Limited Warranty (Such as: Special Effect Lighting, Intelligent 

Lighting, UV lighting, Strobes, Fog Machines, Bubble Machines, Mirror Balls, Par  Cans, Trussing, Lighting 

Stands etc. excluding LED and lamps) 

•  Laser Products = 90-Day Limited Warranty

•  L.E.D. Products = 2-year (730 days) Limited Warranty (excluding motors, PCB boards, and power sup-

plies, which have a 1-year (365 day Limited Warranty) and batteries which have a 180 day 

•  limited warranty).

Summary of Contents for DOT524

























Reviews: