ADF 1000NMV-B, Owner'S Manual, Page: 23 / 36

23
Skamotec 225 can be finished with:
1. EasyMix render (Wet boards thoroughly before applying mix) then painted.
2. Smooth wall plaster (Prime the board first to increase working time, with suitable priming
compound, check with your board supplier), then skim coated and painted.
3. Tiling (Prime the board first before tiling adhesive, with suitable priming compound, check
with your board supplier).
4. For more information check with your Skamotec supplier or Castworks.
Ensure there is a gap of 5mm between the heater metal and the Skamotec 225, to allow for
metal expansion.
Fibreglass mesh tape should be used on all joins. No combustible products should be used in
the combustible clearance zone.
Metal or plastic beading can be used on the corners, but no closer than the minimum
external sizes shown on page 10.