Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
M-Bus Wireless / Ethernet
Document code: MN67084_ENG Revision 1.100 Page 10 of 22
ETHERNET:
The Ethernet port is used for the Ethernet communication and for programming the device.
The Ethernet connection must be made using Connector2 of HD67084-B2-xxxMHz with at least a Category 5E cable. The maximum length of
the cable should not exceed 100m. The cable has to conform to the T568 norms relative to connections in cat.5 up to 100 Mbps. To connect
the device to an Hub/Switch is recommended the use of a straight cable, to connect the device to a PC/PLC/other is recommended the use of
a cross cable.
WM-BUS:
The standards of wM-Bus are specified in EN 13757-4. The signal is @ 868Mhz or 169 MHz
(in relation to the order code). Our converter supports wM-Bus Mode S1 and Mode T1.
The Antenna connector is a SMA Female (‘Female Outer Shell’ and ‘Female Receptacle’) so
the Antenna must have a SMA Male connector.
