ADF Web HD67084-B2-169MHz, User Manual

Page: 14 / 22

Industrial Electronic Devices
ADFweb.com S.r.l.
User Manual M-Bus Wireless / Ethernet
Document code: MN67084_ENG Revision 1.100 Page 14 of 22
SET COMMUNICATION:
This section define the fundamental communication parameters of the two buses, Ethernet and
wM-Bus.
By Pressing the “
Set Communication ” button from the main window for SW67084 (Fig. 2) the window
“Set Communication” appears (Fig. 3). The window is divided in two sections.
The means of the fields for “wM-Bus” are:
In the field “ Mode ” it is possible to select the Communication Mode (S1 or T1 for 868 MHz
version and N1 or N2 for 169 MHz version) used for the M-Wireless Communication;
In the field “ Radio Channel ” it is possible to define the Radio Channel used for the wM-Bus
communication (only for 169 MHz version).
If the field “ Enable Filtering ” is checked, it is possible to filter the data, sending on Ethernet
only the data defined in the section “wM-Bus Access” (See page 15);
If the field “ Received Signal Strenght Indication ” is checked, it is possible to add a byte at
the end of the Ethernet frame to indicate the Strenght of the wM-Bus signal (dBm);
If the field “ Link Quality Indication ” is checked, it is possible to add a byte at the end of the
Ethernet frame to indicate the quality of the wM-Bus signal (1, 2 or 3):
o
1: Low Quality
o
2: Middle Quality
o
3: High Quality
If the field “ Lenght ” is checked, it is possible to add a byte at the start of the Ethernet frame to
indicate the lenght of the frame (only wM-Bus data).
The means of the fields for “Ethernet” are:
In the field “ IP ADDRESS ” insert the IP address that you want to give to the Converter;
In the field “ SUBNET Mask ” insert the SubNet Mask;
In the field “ GATEWAY ” insert the default gateway that you want to use. This feature can be
enabled of disabled pressing the Check Box field;
In the field “ Port ” insert the TCP port used for the Ethernet communication;
In the field “ IP Companion ” insert the IP Address of the device to send the informations
from wM-Bus.
Figure 3: “Set Communication” window