ADEO Services 3276007383232, Instructions Manual

Page: 87 / 95

171 172
EN EN
Mounting the Auxiliary Handle
The side handle can be fitted to the left, right of the unit. Select the position
which gives the most comfortable and safe use.
CAUTION:
Always be sure that the side grip is installed securely before operation. During
operation, keep one hand on the rear handle and the other on the side handle.
Installing or moving protective cover
WARNING:
Ensure the angle grinder is switch off and unplugged from the
mains.
Depending on whether your operation is cutting or grinding, select the correct
protective cover. Failure to use the right cover for operation could result in inju-
ry. When using a grinding or cutting-off wheel, the protective guard must be fit-
ted on the tool so that the closed side of the cover always points toward the op-
erator.
Mounting and removing the Guard
Mounting
Place the angle grinder on a ¦at and steady surface, spindle up.
Align the lug with the slot in the bracket.
Press the guard down and turn it in the direction of the arrow until it is in the
working position providing maximum protection to the user.
Insert the bolt to the holes on the bracket, Screw the nut on the thread of the
bolt.
Use a 4mm hex wrench (not supply) to tighten the bolt and nut.
Do not operate the grinder with a losse guard.
Removing
Follow the procedure above in reverse orders.
Use a 4mm hex wrench (not supply) to loosen the nut, turn counterclockwise to
2 salient points, align and remove the guard. Please note that there are limited
points on the screw to ensure that the nut cannot be unscrewed when it is un-
screwed to a certain position.
Please use grinding protective cover for grinding operation.
Grinding and Surface Processing
In order to grind surface, you should use a coarse abrasive disk with a sunken
centre.
You can use the abrasive disks with diameter of 125mm. The maximum thick-
ness of disks is 6mm.
Mounting the Wheels /Disks
Place the back flange A over the spindle making sure that it fits tight.
Place the grinding or cutting disc B on the top of the back flange, ensuring the
bore fits into the step of the flange.
Mount the concave recess side of the external flange C over the spindle.
Press the spindle lock button to lock the spindle firmly, then tighten the exter-
nal flange with the spanner in clockwise direction.
Allow the angle grinder to run in idle at least 1 minute with the grinding or cut-
ting disc correctly assembled, a vibration disc should be immediately replaced.
A
C B
(Thick)
A
C B
(Thin)