ADEMCO LYNX, User Manual

Page: 14 / 16

–
14 –
POWERLINE CARRIER DEVICES WORKSHEET FOR *80, and *81.
Applicable only if Powerline Carrier Devices are to be used, or chime-by-zone feature is used.
✱
80 OUTPUT DEVICES
Fill in the required data on the worksheet on below and follow the programming procedure in the Installation Instructions as
you enter the data during the displays and prompts that appear in sequence.
Note: Field
✱
25 must be programmed with a House Code.
S T A R T
either or both
S T O P
either or both
DEVICE
NUMBER
ACTION
(aa)
EVENT ZONE
TYPE LIST
(et) (zl)
ZONE TYPE
SYST OP'N
(zt)
RESTORE
ZONE LIST
(zl)
ZONE TYPE
/SYST OP'N
(zt)
P.L.C.D.
*
01
P.L.C.D.
*
02
P.L.C.D.
*
03
P.L.C.D.
*
04
P.L.C.D. *
05
P.L.C.D .*
06
SYSTEM
07
P.L.C.D. *
SYSTEM
08
P.L.C.D. *
*
P.L.C.D. = Powerline Carrier Device (X-10).
Where:
A = DEVICE ACTION 0 = No Response; 1 = Close for 2 sec; 2 = Close and stay closed; 3 = Pulse on and off.
ET = EVENT TYPE 0 = Not used; 1 = Alarm; 2 = Fault; 3 = Trouble.
Z L = ZONE LIST 1, 2, or 3 (from Field ✱ 81) or 0 = Not Used.
"START" ZONE LIST: Upon alarm, fault, or trouble of ANY zone on this list, device action will START.
"STOP" RESTORE of ZONE LIST: Upon restore of ALL zones on this list, device action will STOP. It
need not be same list as used for START.
NOTE: Do not assign zones with zone types 20, 21, or 22 to a zone list.
ZT = ZONE TYPE/SYSTEM OPERATION Choices for Zone Types are:
00 = Not Used 06 = 24 Hr Silent
01 = Entry/Exit#1 07 = 24 Hr Audible
02 = Entry/Exit#2 08 = 24 Hr Aux
03 = Perimeter 09 = Fire Zone
04 = Interior Follower 10 = Interior w/Delay
05 = Trouble Day/Alarm Night 24= Silent Burglary
Note: Any zone in "ZT" going into alarm,
fault, or trouble will activate device.
Any zone of that type that restores
will stop device action.
Choices for System Operation are:
20 = Arming–Stay 38 = Chime
21 = Arming–Away 39 = Any Fire Alarm
22 = Disarming (Code + OFF) 40 = Bypassing
31 = End of Exit Time 42 = System Battery Low * Or at Disarming, whichever occurs
32 = Start of Entry Time 43 = Communication Failure earlier.
33 = Any Burglary Alarm 52 = Kissoff
36 = *At Bell Timeout 58 = Duress
Note: In normal operation mode:
For Devices 1-6:
For Devices 7 and 8: N = device (unit) number
Fu Lights On + N Code + Fu 4 + N (Entry starts Device N)
Fu Lights Off + N Code + Fu 7 + N (Entry stops Device N)