ADEMCO AHDR1, User Manual, Page: 37 / 70

User’s Manual
36
Highlight the box beside
Audio In.
Pressing the button toggles between
Mic In
and
Line
In
.
Mic In
is for an unamplified source while
Line In
is for an amplified source.
You can save your changes by highlighting
OK
and pressing the button. Selecting
Cancel
exits the screen without saving the changes.
NOTE: The DVR will NOT record audio when the recording speed is set to less
15 ips (8-hours mode) for NTSC and 12.5 ips (12-hours mode) for PAL.
Remote Control Setup
Highlight
Remote Control
in the Main Menu and press the button. The
Remote Control
Setup screen appears.
Remote Control Setup
Remote Control On .
Unit ID 0 .
Baud Rate 9600 ..
Date Bit 8 .
Stop Bit 1 .
Parity None .
OK Cancel .
Figure 34 — Remote Control Setup screen
Highlight the box beside
Remote Control
and press the button. This toggles between
On
and
Off
.
NOTE: When Remote Control is Off , none of the settings can be changed.
Highlight the box beside
Unit ID and press the button. You can use the slider bar to set the
unit ID from 0 to 99.
CAUTION: Each DVR should have different Unit ID number so that the
controller can differentiate between DVRs when multiple DVRs are connected
via RS485.
Highlight the box beside
Baud Rate and press the button. A list of baud rates ranging
from 300 to 115,200 appears. Highlight the baud rate for your system and press the button.