ADEMCO AHDR1, User Manual, Page: 25 / 70

User’s Manual
24
REC (Record) Button
Press the
REC button to set the DVR so that it is ready to record video. A red dot appears on
the screen and REC appears on the counter display when the DVR is recording video. Press
the button again to stop recording video.
Shuttle Ring
The Shuttle Ring only functions in the Playback mode. The Shuttle Ring is spring loaded and
returns to the center position when released. Turning the ring clockwise plays video forward.
Turning the ring counterclockwise plays video backward. Playback speed varies with the
amount the ring is turned. The playback speeds are x0.5,
, , , x0.5, , ,
and .
When you release the ring, it snaps back to the center position and the video pauses.
Jog Dial
The Jog Dial only functions when playback video has been paused. By turning the jog dial
clockwise, you can play video forward image-by-image. By turning the jog dial
counterclockwise, you play video backward image-by-image.
Turning on the Power
NOTE: The DVR power cannot be turned on if the hard disk drive door is open.
Press the
POWER
button to turn on the DVR. The unit will take approximately 30 seconds to
initialize. While it is initializing, the DVR will display HELLO . Then, the HELLO will start
moving to the left.
NOTE: If after initializing the unit displays Error , it is most likely that the hard
disk drive is not installed. Unplug the power cord, and make certain the hard
disk drive is installed. If you still get the
Error message after correctly
installing the hard disk drive, contact your dealer or installer.
The
POWER button can also be used to turn off the power once the DVR has completed its
initialization process. However, this is a protected feature requiring an administrator
password.