10
Installation Instructions
POWER SUPPLY
Cameras are available in AC mains, and AC and DC low voltage types.
The voltage required
to operate the camera is clearly marked on the rear panel of the camera
.
Low
voltage cameras must be powered from a UL listed class 2 power supply
. The typical
power consumption of a camera is less than 5 Watts.
Mains power supply
Cameras that are intended to operate directly from the mains supply are fitted with a non-
detachable power supply cord. The voltage of operation is clearly marked on the rear panel of
the camera. REFER TO THE WIRING INSTRUCTION LABEL ATTACHED TO THE SUPPLY CORD
and terminate the cord with the appropriate mains plug fitted with a 3A fuse.
MAINS CAMERAS MUST BE CONNECTED TO A PROTECTIVE EARTH GROUND
.
Ensure that a secure means of isolation from the mains is provided for the camera in accordance
with the national wiring regulations of the country of installation.
Auto-switching power supply
Cameras fitted with an automatic switching power supply operate between 11-28 VDC and
20-29 VAC. Connections are indicated above the terminals on the rear panel of the camera.
The power supply must be a UL listed class 2 type
.
LENS SELECTION
Suitable lens types are C and CS mount in fixed iris, manual iris, auto iris or direct drive versions.
Sizes are shown below. Cameras are factory set for CS mount lenses. If using a C mount lens,
rotate the back focus adjustment mechanism fully clockwise (when viewed from the front of
the camera) before fitting the lenssee
Back Focus Adjustment
.
Lens Size
1/3”
1/2”
2/3”
1”
AC
M
5
74
T
P
AC
M
5
74
T
P
X
AC
M
5
75
X
A
CC4
84
T
P
A
CC4
84
T
P
X
A
CC4
85
T
P
X
