ADE VITALIS Series, Operating Manual

Page: 8 / 20

FILLING AND CUTTING
During operation, a correct posture should be taken to avoid accidents. The body must always
be perpendicular to the worktop.
Make sure that no body parts come into direct contact with the running device.
1 Position the collecting pot under the ejection chute so that the magnetic
sensor is positioned close to the housing.
2 Install the appropriate disc with which you want to process your foods as
described under “Assembling the tool discs”.
3 Fill the device through the lid opening. Smaller pieces (e.g. carrots,
zucchini, etc.) are fed through the tube on the lever. Turn on the device and slightly push down the
retaining device. Use the pusher when filling through the tube.
Filling through the lid opening Filling through the tube on the lever
4 Once you have finished, lift the lever. The device is turned off by a safety system. Fill the foods to be
processed. If you push down the retaining device, the device will automatically turn on again.
5
To change the disc, proceed as described under “Assembling the tool discs”. After this operation, an
electronic system prevents automatic power-on. To turn on, press the
“I”
start button.
Exercise utmost care when replacing the discs as there is a risk of cutting with the blades of
the discs.
Make sure that the lid is locked by locking screw before operating the device!
6
Empty the pot after 2-3 cutting cycles. Overfilled pots can compromise the normal discharge process,
possibly resulting in the irregular cut, blocking of the device and damage to the motor.
SENSOR