FL-Cool-200629-Rev003-UM-en
8
Changing the cutting set
A versatile use is ensured by the possibility of changing individual perforated discs - depending on
the desired cutting effect. In any case, the hand wheel must be set up as the last part.
It must be ensured that the cutting set is assembled according to the order
specified in the manufacturer's instructions.
For the perforated disk, which is the last perforated disk to be inserted into the
worm housing, only perforated disks with a hole diameter of less than 8 mm may
be used for safety reasons!
The perforated discs must not be ground thinner than 5 mm!
START-UP
The machine is delivered as standard with red CEE plug (16 A).
Check the voltage indicated on the nameplate with the local power supply.
Then insert the plug into a suitable three-phase socket and the machine is ready for operation.
In three-phase machines, a reverse run may occur due to the different layout of
the local power grids. 2 of the 3 power phases in the plug must then be swapped
by a specialist!
The worm must turn counter-clockwise when switched on!
The plug may only be replaced by a qualified person!
Operating the meat mincer
No.
Description
Meaning
1
Programme
selection
Switch for turning on the device
Switch on the device
Switch off the device
Patty maker operation
2
ON
Power switch (green light edge) - to turn on the mincer unit
3
OFF
Breaker (red light edge) - to turn off the mincer unit
4
REVERSE
Reverse mode switch (white light edge) - to turn on the reverse
rotation of the mincer unit
5
Thermostat
Display of the cooling temperature
1
3
4
5
2
