APCI-7xxx-3
Figures and Tables
59
Your settings will be displayed in the lower part of the main menu of the
MTTY-program (see figure above) under „Comm Status“ (see figure below).
Fig. 8-6: Window: “Comm Status”
You can configure the handshake of the modem control signals according to your
application as follows:
♦
Click in the menu of the MTTY program on „TTY“ and select„Flow
Control“ (see figure below).
Fig. 8-7: Window: „Flow Control“
After this the window „Flow Control Settings“ appears (see figure below).
♦
Here you can do the required settings
Fig. 8-8: Window: „Flow Control Settings”
Summary of Contents for APCI-7300-3
