APCI-7xxx-3
Figures and Tables
12
Uses beyond these specifications are not allowed. The manufacturer is not liable
for any damages which would result from the non-observance of this clause.
Make sure that the board remains in the protective blister pack
until it is used
.
For all operating modes
, the signal lines are to be twisted in pairs with GND.
Use exclusively connection cable with twisted pairs.
The housing of the peripheral connector
-
is to be firmly screwed together with the shield of the cable.
-
is to assure a low-resistance connection (< 100 m
Ω
) between the shield and the
housing of the PC.
The shield of the cable is to be earthed on both ends.
Do not remove or alter the identification numbers of the board.
If you do, the guarantee expires.
Summary of Contents for APCI-7300-3
