Series Cutout (SCO)
Installation
© ADB Airfield Solutions All Rights Reserved
20
96A0294 Rev. G
d. See Figure 13. Connect each output wire (4) to the SCO cutout. Install the clamp. Make sure contact is made with the
shield.
e. Close the SCO cutout and lock it.
f.
See Figure 3 for SCO cutout Positions.
2.4.4.1 Pre-Installed Cutout Installation
A pre-installed cutout typically requires the installation of only the cutout series circuit wiring and possibly the ground wiring.
To wire the pre-installed SCO cutout, perform the following procedure:
1. See Figure 2. Unlock the lock (if depressed) using the key and remove the cover.
2. If using unshielded L-824 wire, connect the CCR input and output wires to the SCO cutout by performing the following
procedure:
a. See Figure 2. Remove and discard the cutout clamp (11) and clamp screws (9) from the cutout. Only the grounding
screws (8) should remain.
b. Strip the input and output cable wires to ½ in. (13.0 mm) from the end of the wire. See Figure 12. Make sure that the wire
strands are not nicked or cut.
c. See Figure 13. Connect the input L-824 wire (1) to the SCO cutout.
d. Connect the output L-824 wire (4) to the SCO cutout.
-OR-
See Figure 14. If using shielded L-824 wire to connect the output wires from the SCO cutout, performing the following procedure:
a. Strip the input and output cable wires to ½ inch (13 mm) from the end of the wire. Make sure that any plastic coating on
the wire is cut off.
b. Connect the input L-824 wire (1) to the SCO cutout.
NOTE:
A shield, if present, is not used.
c. See Figure 2. Remove the clamp (11).
d. See Figure 13. Connect each output wire (4) to the SCO cutout. Install the clamp. Make sure contact is made with the
shield.
e. Close the SCO cutout and lock it.
WARNING
Do not allow the end of the cable wire to extend beyond the output post more than 1/16 of an inch. (1.5 mm)
WARNING
Do not allow the end of the cable wire to extend beyond the input post (2) more than 1/16 of an inch. (1.5 mm)
WARNING
Do not allow the end of the cable wire to extend beyond the output post (3) more than 1/16 of an inch. (1.5 mm)
WARNING
Do not allow the end of the cable wire to extend beyond the input post (2) more than 1/16 of an inch. (1.5 mm)
WARNING
Do not allow the end of the cable wire to extend beyond the output post (4) more than 1/16 of an inch. (1.5 mm)