© ADB Airfield Solutions All Rights Reserved
19
Figure 13:
Connecting CCR Input Terminal Cables
d. Connect the output L-824 wire (4) to the SCO cutout.
-OR-
If using shielded L-824 wire to connect output wires from the SCO cutout, performing the following procedure:
a. See Figure 14. Strip the input and output cable wires to ½ inch (13 mm) from the end of the wire. Make sure that any
plastic coating on the wire is cut off.
Figure 14:
Stripping Shielded L-824 Wire
b. Connect the input L-824 wire (1) to the SCO cutout.
NOTE:
Unshielded cable should be used between the CCR and the SCO.
c. See Figure 2. Remove the clamp (11).
WARNING
Do not allow the end of the cable wire to extend beyond the output post (3) more than 1/16 of an inch. (1.5 mm)
WARNING
Do not allow the end of the cable wire to extend beyond the input post more than 1/16 of an inch. (1.5 mm)
Input Post
Output Post
Output L-824
Wire
Input L-824
Wire
0.39 -
inch
10
mm
0.75 -
inch
19
mm
0.50 -
inch
13.0
mm
W
ire
J
ac
k
et
Shie
l
d
Se
p
arator
0.47
in
. (12
mm
) D
iameter
(M
a
x
imum
) I
nsu
l
ation
0.28
in
. (7
mm
) D
iameter
(M
a
x
imum
) W
ire
Do not pencil the
insulation. The
ends must be
square.
