ADB Safegate RELIANCE Shallow Base, User Manual

Page: 33 / 46

Position the base Image examples
1. Slowly adjust the three screws of the positioning tool until
the bubbles inside the spirit level are centered.
2. Fasten the locking screws.
3.
Check if the base is set in the correct direction using the
most efficient aiming marker, depending on the fitting
types for installation as follows:
a.
For a straight section , use a vertical marker set on
the light beam direction at least 20 m away as an
aiming point. If using a sight telescope (option),
slowly turn the positioning tool to line up the vertical
marker and the grid line in the telescope.
b. For a curved section , set the marker on the center of
the curvature. If using a sight telescope (option),
slowly turn the positioning tool to line up the vertical
marker and the grid line in the telescope.
c. For a transverse line , set the centerline base, see (a),
set a marker on each side of the perpendicular, repeat
(a). If using a sight telescope (option), turn
perpendicularly on both sides of the parallel centerline
(by 90°) for the grid line to coincide with the field
markers.
Note
To position a shallow base (without a sight
telescope), use the two small markers (V) on
the positioning tool with a small laid cord for
vertical alignment and the spirit level
(supplied) on the positioning tool for
horizontal alignment (4).
4.
Remove the sight telescope (option), if used.
5. Pour resin in the hole to set the base (5).
6.
Remove the positioning tool when the resin has
completely set.
7.
Deflate/remove the ball, if used.
UM-0106, Rev. 1.0, 2019/12/19 23
Copyright
©
ADB Safegate, All Rights Reserved