ADB Safegate RELIANCE Shallow Base, User Manual

Page: 26 / 46

4.3.2 Electrical connections in base with side access
Note
If a base with side access is to be installed, it is possible to complete the electrical connections after the base
installation. It should thou be noticed that this is not the general rule for this type of base installation or different
installation processes.
Electrical connections in Base 12” and Base 8”-135-2-X-X (with
side access, full threaded holes)
Image examples
1.
Install the cable gland on the inside of the base and the
plastic tube on the outside. Loose the outer part of the
cable gland to allow the cable to pass (B).
2. Pull the cable through the protection tube and the cable
gland (C).
3. Complete all electrical connections and wire/connector
screenings.
4. Attach the ground wire (A) to its connection point inside
the base using the screw supplied. For systems where
ground connection is used, the ground cable needs to be
equipped with a suitable cable terminal.
Note
If the marked connection point cannot be used,
the screw can be attached to any other place
inside/outside the base.
5. Allow approximately 35 cm secondary cable inside a 12"
base respectively 25 cm inside a 8" base.
6. Tighten the cable gland (B) with 24 mm fork wrench.
Figure 15: Electrical connection in a base with side access
RELIANCE Shallow Base
Installation
16
Copyright
©
ADB Safegate, All Rights Reserved