ADB Safegate RELIANCE Shallow Base, User Manual

Page: 31 / 46

Position and align the base Image Examples
1. Make sure that the hole is clean and completely dry.
2.
Make sure that the outer surfaces of the base are clean
and dry.
3.
Place the base in the installation hole (with the alignment
device).
4.
Center the base in the middle of the installation hole and
align it using the alignment grooves. For center line
alignment, use for example the pre-set aiming target or
use the runway/taxiway edge as a reference. For a curved
section, use the pre-set center point marker.
5. Check that the alignment device is set to the correct
angle, the base is in the middle of the installation hole
and alignment is correct.
6.
For a bottom-hole base, make sure that the bottom hole
is correctly sealed.
Figure 19: POSITION & ALIGN
Set up alignment devices Positioning jig for 8”/12” bases and
Sight Telescope (optional)
Image examples
1. Degrease and dry the base, if required.
Note
This is not required if the base is new from the
box.
2. Place a specific positioning tool (8" or 12") on the base.
3.
Fasten the fixing knobs (nuts).
4. Carefully place the base inside the bore hole.
UM-0106, Rev. 1.0, 2019/12/19 21
Copyright
©
ADB Safegate, All Rights Reserved