ADB Safegate REIL-L, User Manual

Page: 23 / 60

3.0 Installation
This section provides instructions for installing the L-849 Runway End Identifier Lights (REIL). Refer to the airport project plans
and specifications for the specific installation instructions. Also see FAA AC 150/5340-30.
Warning
Read the instructions in their entirety before starting installation.
•
Refer to the FAA Advisory Circular AC 150/5340-26, Maintenance of Airport Visual Aids Facilities, for instructions
on safety precautions.
•
Observe all safety regulations. To avoid injuries, always disconnect power before making any wiring connections or
touching any parts. Refer to FAA Advisory Circular AC 150/5340-26.
•
Become familiar with the general safety instructions in this section of the manual before installing, operating,
maintaining or repairing this equipment.
•
Read and carefully follow the instructions throughout this manual for performing specific tasks and working with
specific equipment.
•
Make this manual available to personnel installing, operating, maintaining or repairing this equipment.
•
Follow all applicable safety procedures required by your company, industry standards and government or other
regulatory agencies.
•
Route electrical wiring along a protected path. Make sure they will not be damaged by moving equipment.
•
Protect components from damage, wear, and harsh environment conditions.
•
Protect equipment with safety devices as specified by applicable safety regulations.
•
If safety devices must be removed for installation, install them immediately after the work is completed and check
them for proper functioning prior to returning power to the circuit.
3.1 L-849A/E REIL: Required Equipment
Refer to Table 2 for required equipment that is supplied. Refer to Table 3 for required equipment that is not supplied. Refer to
the Parts section for ordering information.
Table 2: Required Equipment Supplied
Description Quantity
REIL system 1
Instruction manual 1 per order
Table 3: Required Equipment Not Supplied
Description Quantity
Wire, input power. (AWG 16, 600V min. assuming distance is 600 feet
or less). See Table 4 if distance >600 feet.
As required
Wire, remote control (AWG 16, minimum, 600 V) As required
Wire, interconnection individual control cabinets (AWG 16, minimum,
600 V)
As required
Remote control device As required
Ground rods and AWG 6 solid copper ground wire As required
External circuit breaker for voltage powered REIL 1
Base pads, cement for mounting cabinets As required
96A0461, Rev. H, 2019/10/31 13
Copyright
©
ADB Safegate, All Rights Reserved