Press and hold the control dial in for 3 seconds until the light blinks green
Press and hold the control dial in for 3 seconds until the light blinks red
P1 P2
Adax ET ECO S .1
Explanation of programmes/modes/settings:
P1
- Lower temperature at night (night-time heating)
P2
–
Programmes
Manual programme (works the same as when
starting
the radiator for the first time
–
Step 1)
Power cut
When a power cut occurs, the radiator will remember the settings (temperature) that were set
before the power cut occurred. It will start heating up again as soon as the power is on. If the temperature is changed,
the light will blink red
–
indicating a power outage.
To adjust the temperature, you must follow Step 1
“
Starting the radiator for the first time
”
.
If the radiator is turned off for a long period (e.g. during the summer), the light will blink red
when it is turned on again
–
follow the process for
Step 1
.
Child safety mode
The thermostat (control dial) can be locked to prevent children and others changing the radiator’s settings and temperature
.
Activate child safety mode
1. Turn the control dial to the desired temperature (e.g. 22°C)
2.
3.
If you turn the dial at this point, the light will blink red. You cannot change the temperature
.
Turn off Child safety mode
1. Turn the control dial with the arrows (show the symbols) as when turning the radiator on
2.
3.
When the child safety mode is turned off, the radiator will heat at 22°C. Adjust to the desired temperature
.
EN
Thermostat user instructions
Step 1. Starting the radiator for the first time
Follow the steps below
–
this process is used when you start
the radiator for the first time, and to reset the radiator after a power cut.
This calibrates and resets all settings.
1. Plug the radiator in to an electric outlet
2. Turn on the radiator
3.
Adjust the control dial
so 2 arrows face each other (22°C)
pointing towards the light
4. Press and hold the control dial in for 1 second untilthe light blinks green
5.
The radiator is now correctly set up and you can setthe temperature you
require.
This process will reset all other settings; it is used when, for example,there
has beena power cut or if you want to cancel the night-time heating
programme.
