PROGRAMMING THE SIGN IN “VIOLATOR ALERT” MODE
This section covers setting the standard “Violator Alert” functions including the optional
“Slow”, “Red & Blue” flashing signals.
Note:
The pushbutton instructions described in the
following paragraphs also apply to the use of the key chain remote control buttons.
Turn power on. After the brightness number changes, push the button and stop on
“VA”. The display is now in “Violator Alert” setup mode. The Violator Alerts 1 to 5 will
then begin to appear in the order of the photos as shown below.
Note:
If the Timer is
enabled, (see Section 11 “Setting the Clock and Timed Events) the sign will run in
Violator Mode (or any other mode) only during the selected event timed program.
Otherwise, if the timer is disabled, the sign will run continuously (not recommended for
overly long periods of time when on battery power only).
“Violator Alert”
Violator Alert 1: MS - Minimum Speed
After seeing the “VA” screen, the display will show “MS” (see photo below) along with a
number. The number represents the lowest speed at which the display will start
showing all oncoming vehicles. When this number appears, the operator has 5 seconds
within to start pushing the button in order to program this “MS” speed setting. Press the
button until the desired speed setting is reached. (Note: If the button is held down, the
numbers will increment fast without having to press the button many times. The
numbers will start over after 99 if you miss your desired speed without turning off the
power. If using the key chain remote, simply press either button to move the numbers
forward or backward). Once the desired setting is reached, stop and wait for the next
screen to appear after approximately 5 seconds. The screen will then change to the next
screen for speed setting.
Adaptive Micro Systems LLC | 7840 North 86th Street | Milwaukee, WI 53224
Phone (800) 558-7022 | AdaptiveDisplays.com
