acceleration or deceleration), the display will simply hold the last recorded speed for a few
seconds rather than jumping back and forth between speeds. A couple of examples:
Example 1:
If a vehicle is traveling at 35mph and the car behind him is traveling
at 40mph, the sign will display the first vehicle at 35 until it
passes. The first vehicle’s speed will show for 1-1/2 seconds after
it passes, so the radar can establish and display vehicle two’s
speed at 40mph.
Example 2:
If a vehicle accelerates towards the sign from a stop at greater than 3
miles per hour per second, no speed will be displayed. If a vehicle
accelerates at 3 miles per hour per second or less, the sign will
display the speed as it increases.
10.
ADVANCED FEATURES
In addition to the standard features there are some advanced features available mainly for
trouble shooting. To enter the Advanced Feature mode, turn the unit ON and press the
programming button five (5) times before the intensity number blinks. First an “A” will appear
on the left digit and a number on the right. Press the programming button until the
appropriate number is shown for that slot. Wait for a “B” to appear and repeat this for “C” and
“D” as well. This will put you into that mode until the unit is turned off and back on again. See
below a list of codes and slots for these advanced features.
A
B
C
D
9
9
6
9
9
9
7
1
9
9
7
3
9
9
7
5
9
9
7
9
9
9
8
1
9
9
8
3
9
9
8
7
9
9
8
9
Minimum Speed Mode
Alternate “Slow” Violator Alert Mode
Demo mode (see further instructions)
Show Serial Number
Display Diagnostic Mode
Auto Intensity Diagnostic Mode
Turn On & Off Radar Acceleration Filter
Turn On & Off No Display Availability
Turn On & Off Set Time Availability
Minimum Speed Mode
Lower speeds of 5 mph are distracting in most applications but are desirable in some. As a
default, the display will only show down to 5 mph but down to 1 mph is available. Putting in
the minimum speed code will turn on and off the down to one mode. If after putting in the
minimum speed code, the display shows “S1” then the speed will show down to 1 mph. If “S5”
shows then the speed will only show down to 5 mph.
Alternate Slow Violator Alert Mode
The display can show the “Slow” violator alert two ways. One is that only “Slow” is shown if the
vehicle speed is over that set speed. The other is that the “Slow” will show and then the vehicle
speed will display, alternating between the two until the vehicle slows below the set speed.
Both are very effective but one could be preferred above the other. The default is just “Slow”.
To switch from one or the other, put in the code and if the display shows “On” then only the
“Slow” message will display. If after the code is put in and “Off” shows then the display will
alternate between “Slow” and their speed.
Adaptive Micro Systems LLC | 7840 North 86th Street | Milwaukee, WI 53224
Phone (800) 558-7022 | AdaptiveDisplays.com
